homedecorcreation 
Nowadays, there are so many products of rv heating tape in the market and you are wondering to choose a best one. You have searched for rv heating tape in many merchants, compared about products prices & reviews before deciding to buy them.
You are in RIGHT PLACE.
Here are some of best sellings rv heating tape which we would like to recommend with high customer review ratings to guide you on quality & popularity of each items.
HEATIT JHSF 40-feet 120V Self Regulating Pre-assembled Pipe Heating Cable
- JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com).
- Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional.
- Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather.
- ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. Four year limited warranty. If you are not completely satisfied with HEATIT heating cable, please feel free to contact us in any time, we’ll try our best to solve your issue
Similar items with 4 stars and above
Frost King HC30A Heating Cables, 30 Feet, Black
Camco 25′ 25ft TASTEPure Heated Drinking Water Hose with Energy Saving Thermostat-Lead and BPA Free (22911)
- Ideal for water line freeze protection down to -20˚F (-28˚C) with an energy saving thermostat
- Made with NSF-61 certified drinking water safe hose
- Includes female-to-male adapter to allow connection to the water supply on either end of hose
- depending on the location of the electrical outlet
- Durable exterior jacket protects water hose and electrical components from damage or exposure
- Operates on 120VAC
The core of the Camco Taste PURE Heated Drinking Water Hose is made with an NSF 61 certified, drinking water safe hose that is BPA, phthalate and lead free. The Heated Drinking Water Hose won’t leach harmful chemicals into your water or leave it tasting like plastic the way standard garden hoses do. It is ideal for RVs, livestock, agriculture, kennels and other industrial, commercial and residential uses. Its energy saving thermostat only heats as needed, saving you money on your electric bill. The fittings are heavy duty machined and plated for maximum corrosion resistance and the durable exterior jacket protects water hose and electrical components from damage or exposure. CSA Low Lead Content Certified to NSF/ANSI 372. Compliant with all federal and state level Low Lead Laws.
Facon 12" x 18" Holding Tank Heater Pad for RV Camper Trailer with Automatic Thermostat Control (Pack of 2)
- Heater pads are designed and engineered to protect RV holding tanks, pipes and steps from freezing. Winter convenience of Today’s RV’er. Provides water for RV Trailer mobile home in Winter.
- Pad Size: 12” x 18”, works efficiently up to 50 gallon holding tanks.
- Built in thermostat is set to turn itself on at 45°F( + – 5 degrees) and turn itself off at 68°F( + – 5 degrees). As long as the on/off switch is in the on position and electrical power is supplied, the thermostat will continuing cycle preventing freezing.
- Self adhesive make it easy installation, 3mm foam insulation pad, no extra facility required. Reticular carbon fiber design provide heated evenly & efficiently.
- 2-Wires Design without Plug- Convenience for fixed place installation. Includes Lead Wire for Power(Red wire) and Ground Wire(White wire)
EasyHeat 2102 Freeze Free Heating Cable – 100′
- Self-regulating pipe heating system
- Provides flexible protection against pipe freeze-ups in even the most challenging applications
- Reduces power consumption when the pipe does not require freeze protection
- Ideal for use on residential metal or plastic water supply and drain pipes subject to freezing temperatures
- Length: 100′ and rugged metal braided jacket provides an electrical ground as well as protection against damage
EasyHeat Freeze Free self-regulating pipe heating cables provide flexible protection against pipe freeze-ups in the most challenging applications. The cut-to-length technology is ideal for installations that require protection of numerous pipes of varied lengths. The self-regulating effect of the cable reduces power consumption when the pipe does not require freeze protection. They are ideal for use on residential metal or plastic water supply and drain pipes subject to freezing temperatures; water supply lines underneath manufactured homes; and cottages, barns and outbuildings that are not regularly used.
HEATIT HISD 24-feet Pipe Heating Cable with Built-in Thermostat
- Use for water filled plastic (including PEX) or metal pipes. Not use for anything else, like empty water pipes, fuel lines, hoses, gutters, steam lines and so on. Two year limited quality . If you are not completely satisfied with HEATIT heating cable, please don’t hesitate to contact our customer service in any time, we’ll try our best to solve your issues.
- Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid.
- Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket.
- Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight.
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off.
Similar items with 4 stars and above
WRAP-ON Pipe Heating Cable – 60-Feet, 120 Volt, Built-in Thermostat, Low Wattage – 31060
- BUILT-IN THERMOSTAT – Turns the cable on at 38 degrees F and prevents frozen pipes to -50 degrees F – Simply wrap on, insulate and plug in. Insulation sold separately.
- PRESS-TO-TEST BUTTON – Exclusive feature to test cable before or after installation.
- ENERGY EFFICIENT – Uses up to 65% less energy at 2 watts per foot vs other cables at 7 watts per foot.
- USE ON ALL RIGID PIPES – PVC, CPVC, copper and metal pipes.
- MADE IN THE USA
Product Description
Prevents frozen water pipes to –50F. Simply wrap on, insulate and plug in. Engineered for use on metal and rigid plastic pipes. Uses an exclusive Press-To-Test button so you can test the cable before installing. A built-in thermostat turns the cable on at 38F. Proven low-wattage design uses up to 65 percent less energy at 2 watts a foot vs. other cables at 7 watts a foot, and protects to –50F. An exclusive power sensor light glows when the thermostat is closed. Each package contains one ready-to-install pipe heating cable along with installation instructions. To install, you will also need PVC/electrical tape, fiberglass pipe insulation, a tape measure and eye protection. Warning: This cable has been designed for the sole purpose of preventing metal and rigid plastic water filled lines from freezing. DO NOT use this product on fuel lines, drain lines, hoses or buried pipes. Fiberglass pipe wrap is required to complete the installation. Read and follow all instructions. Cables are available in various lengths. See chart to determine the length required for your application.
From the Manufacturer
Pipe Heating Cable – 31060 60Ft. Ul Pipe Heat Cable
HEATIT Mobile Home 100-feet HEATIT HTM Braid Self Regulating heating cable Water Line Freeze Protection
- HEATIT is registered Trademark by zhukeshi (We didn’t authorize other sellers in Amazon.com). HTM self-regulating pipe heating cable system is designed for mobile home and other dry applications etc. Can be used on residential metal or plastic water supply and drain pipe freezing protection.
- ETL approved. Tinned copper braid as the out jacket as well as electrical ground. Self regulating heating cable just deliver the heat where is need. The cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional.
- Additional tools which you may need: High quality electrician’s tape such as HEATIT glass cloth tape, 1/2” thick fiberglass insulation with vapor seal, wire cutters or heavy scissors, Phillips#2 slotted screw drivers, Ruler or measuring tape.
- HEATIT HTM connection kit is necessary for the pipe freeze protection application. Please purchase this kit separately.
- Quick test: Once insulation is finished, plug the cable into a 120V AC outlet. Don’t use any of the water for about 1 hour. After that turn on the tap on HEATIT HTM protected pipe and test the water temperature. You should feel the slight warm from the water.Three year limited warranty. If you are not completely satisfied with HEATIT heating cable, please feel free to contact us in any time, we’ll try our best to solve your issue
Similar items with 4 stars and above
JR Products HTH-A RV Hardware
- JR Products Holding Tank Heater – Holding tank heating element is an easy and practical way to winterize your RV tanks
- Can be used on either fresh or septic tanks
- Dual voltage ready for both 12 volt and 110 volt applications
- Elements are thermostatically controlled and activate at approximately 34 degree Fahrenheit to stop the contents of your tank from freezing
- Approximately 1 Amp AC and 10 Amps DC current when in use
JR Products Holding Tank Heater – Holding tank heating element is an easy and practical way to winterize your RV tanks. Can be used on either fresh or septic tanks. Dual voltage ready for both 12 volt and 110 volt applications. Elements are thermostatically controlled and activate at approx. 34deg. F to stop the contents of your tank from freezing. 30in x 13 inch element is foil-covered heater; comes with a 24 inch ground wire for safety, 6 Feet of 120 volt wiring for easy installation. Draws approx. 1-amp AC and 10-amps DC current when in use. Heats tanks up to 15 Gallon size. Multiple elements can be used where needed. Holding Tank Heater.
Conclusion
By our suggestions above, we hope that you can found rv heating tape for you.Please don’t forget to share your experience by comment in this post. Thank you!
