The 9 Best Hot Water Tank Booster

Tank Max – water heater protects your family from scalding by allowing water to be 140 degrees (F) in the water heater while distributing 120 degree (F) water to fixtures. Lead-free and easy to install, tank Max saves money by extending the life of the hot water in your water heater. No solder or glue needed. Installation requires only a wrench and pipe thread sealing tape. Product specifications PDF below.

Get hot water where it’s needed, when it’s needed with the Bosch ES4 Tronic 3000 T Electric water heater. This 4-gallon capacity point-of-use mini-tank fits right under your sink and provides a practical and effective solution to your hot water needs. This smaller model can be plugged right into a 120-volt outlet with the 36-37″ cord, or can be installed in-line with a larger hot water source to provide “on-demand” use. The glass-lined tank offers great insulation and added durability, while the heater’s fast recovery rate eliminates long waits for hot water. An external dial allows you to easily control the temperature range, and the temperature-and-pressure relief valve enhances your safety. The ES4 Tronic 3000 T from Bosch has a sleek and attractive exterior design that blends in seamlessly with existing décor when installed in a visible location, making this heater a great option in any room. Water Heater measures 13.75″ H x 13.75″ L x 13.5″ D and weighs 17.3 lbs. Do not operate this water heater if it is has a damaged cord or plug, if it is not working properly, or if it has been damaged or dropped

Eco Smart ECOTB240

Product Description

This Smart Technology electric tankless water heater is configured as a “whole home” model for climates where incoming water temperature is 67°F and above. This model is well suited for heating up to 2-Gallon per minute, which is the equivalent of one shower head (with a 1.5 gpm flow) and one sink with a low inlet water temperature of 67°F and an output setting of 105°F. Digital Temperature Control allows you to set your temperature in increments of 1 Degree. This model can also be used in colder climates as a Point of Use for a sink or other low flow application. All tankless water heaters are sized based on flow rate and temperature rise, and there is a direct relationship between the two. So if used in a cold area requiring a high temperature rise, it will be more limited in the amount of fixtures (gallons per minute) it can heat at one time compared to a warmer climate. When sized properly this water heater will provide endless hot water and only consume the energy needed, giving the user complete control. Prior to purchase and installation please verify this model is the right size for the expected demand and electrical requirements. The ECO 11 requires a minimum 125 amp electrical panel for installation with (1) 60 amp double pole breaker connected to (1) set of #6 awg wire. Plumbing connections are 1/2″ compression fitting with the option of 1/2″ NPT adapter included. For additional assistance please feel free to contact our support center at 877-474-6473.

NOTE : 11Kw at 220 is equal to 13kw at 240.

From the Manufacturer

This Smart Technology electric tankless water heater is configured for climates where incoming water temperature is 67 Degree F and above. This model is well suited for heating up to 2-Gallon per minute, which is the equivalent of one shower head (with a 1.5 gpm flow) and one sink with a low inlet water temperature of 67 Degree F. Digital Temperature Control allows you to set your temperature in increments of 1 Degree. This model can also be used in colder climates as a Point of Use for a sink or other low flow application. Prior to purchase and installation please verify this model is the rights size for your hot water needs and electrical requirements.

Product Description

This electric tankless water heater is a true Point of Use Model because it is specifically designed for under the sink, single applications with a maximum flow rate of 0.5-Gallon per minute (gpm) and includes a 0.5 gpm sink aerator. This heater is flow controlled, meaning the temperature will adjust according to flow rate. It is the smallest sized Ecosmart electric tankless model and should not be used to run anything more than one sink at a time or used in areas where inlet water temperature is lower than 57°F. At this inlet temperature the ECO POU 3.5 can heat 0.5 gallons per minute to 105°F. Its compact size allows for under the sink installations. The Point of Use models are ideal for: Wet Bars, Strip Malls, Doctor’s Office, Boats, Recreational Vehicles (RVs), Bathroom Sinks. When sized properly this water heater will provide endless hot water. Prior to purchase and installation please verify this model is the right size for the expected demand and electrical requirements. The Eco POU 3.5 requires a minimum 100 amp electrical panel for installation with (1) 30 amp single pole breaker connected to #10 awg wire. Plumbing connections are 1/2″ NPT. For additional assistance please feel free to contact our support center at 877-474-6473. TROUBLE SHOOTING STEP: When the water is not hot enough, please slow down the flow of water to increase temperature!

From the Manufacturer

This electric tankless water heater is a true Point of Use Model because it is specifically designed for under the sink, single applications with a maximum flow rate of 0.5-Gallon per minute (gpm) and includes a 0.5 gpm sink aerator. Its compact size allows for under the sink installations. The Point of Use models are ideal for: Wet Bars, Strip Malls, Doctor’s Office, Boats, Recreational Vehicles (RVs), Bathroom Sinks. Prior to purchase and installation please verify this model is the rights size for your hot water needs and electrical requirements.

Save water by eliminating the wait for hot water to reach the faucet. Simply tap into the water line and install the heater directly at the sink. No need for costly recirculating lines and pumps. And when you want to eliminate the wait for hot water but need more volume, install the Eco smart heater in-line with a larger hot water source, such as a tankless heater or a storage tank heater. Lightweight and compact, these units plug into a standard 110 volt outlet.

Running out of hot water? Optimize the performance of your current or new water heater tank with the Eemax TankBuddy Water Heater Booster. Increase deliverable hot water up to 45% which nearly doubles your shower time. Easy installation on new or existing tank water heater, so no need for additional electrical infrastructure when used with an existing electric water heater. Save space – TankBuddy is compact and fits right on top of the tank or can be wall mounted, and save money – no need to upgrade to a larger, more expensive tank. Set temperature in increments of 1 degree Fahrenheit with the easy to use digital user interface.

More Hot Water

When you install Eemax TankBuddy, you’ll get nearly twice as much shower time from your hot water heater. It’s that simple. More hot water, when you need it.

Save Money

You’ll save money with TankBuddy with low, one-trade installation costs, versus installation of a larger tank. Plus, TankBuddy’s energy efficient design will save money on utility bills.

Save Space

TankBuddy’s small design increases your tank’s performance without taking up a ton of space. The booster sits on top of your tank or can be wall-mounted nearby.

Reliable Precision Heating Technology

Eemax has developed products that can provide safe, reliable hot water for hand washing applications, as well as heavy duty safety showers. Customers know they can count on Eemax to have the right technology for every application. Eemax provides hot water where you need it, when you need it.

Conclusion

By our suggestions above, we hope that you can found hot water tank booster for you.Please don’t forget to share your experience by comment in this post. Thank you!