homedecorcreation 
Nowadays, there are so many products of pipe heating element in the market and you are wondering to choose a best one. You have searched for pipe heating element in many merchants, compared about products prices & reviews before deciding to buy them.
You are in RIGHT PLACE.
Here are some of best sellings pipe heating element which we would like to recommend with high customer review ratings to guide you on quality & popularity of each items.
HEATIT HISD 3-feet Pipe Heating with Built-in Thermostat, Black
- Use for water filled plastic (including PEX) or metal pipes. Not use for anything else, like empty water pipes, fuel lines, hoses, gutters, steam lines and so on. Two year limited quality . If you are not completely satisfied with HEATIT heating cable, please don’t hesitate to contact our customer service in any time, we’ll try our best to solve your issues.
- Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid.
- Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket.
- Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight.
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off.
- Copper
Similar items with 4 stars and above
Dernord 2 Inch (OD64) Tri-clamp Ripple Heating Element Electric Water Heater 5500W 240V
- Stainless Steel Tri-clover Clamp 2 Inch (OD64), fit 2″(51mm) pipe if that pipe has a 2″ flange for triclamp
- With SUS304 Materials Cap,easy to Install and fits Standard 2″ tri-clover coupler of American
- Nylon Cable Gland Joint Adjustable Locknut for PG21 Wire OD 12.5mm to 18mm
- SUS304 Tri-clamp Ripple Foldback heating element provides 5500w 240v of power
- Resists dry firing, lime deposits, and sand that would burn out ordinary elements
Product Features
5500W Tri-clamp Ripple Foldback heating Element : Replacement American standard water heater parts
From the Manufacturer
Dernord 240v 5500w Immersion Tri-clamp Ripple Foldback Brewing Water Tubular Heater Element has a compact, energy efficient design that is well suited for many applications. The element is folded back to minimize length and maximize the heated surface.It provides uniform heat distribution and offered long performance life, and fits more models of American,for Bradford White, Craftmaster, General Electric and Whirlpool heaters.
Technical Details
Item Weight: 26.5 ounces
Origin: China
Color: Silver
Tube length: 333mm
Tube diameter: 8mm
Ferrule Size: 51mm Pipe OD, 64mm Ferrule OD, 48mm Pipe ID
Twidec/ 12x80mm Cylinder Cartridge Heater 110V 250W Hot Rod Heating Element Replacement Electric Heating Pipe Fittings
- Product Name: Cartridge Heater
- Widely used for manufacturing plastic and rubber parts in the car industry or in the food processing industry, etc .
- Material: Stainless Steel,PVC,Nylon
- Main Color: Silver Tone, Blue
- Rated Voltage :AC 110V
- Power :250W
- Heater Size(Approx.): 12 x 80mm/0.48″ x 3.1″(D*L)
- Wire Length(Approx.) :27cm/10.7″；Net Weight :50g
- Package Content :1 x Cartridge Heater
Specially designed for heating applications, such as injection molding machine, dies, hot plates, platens, etc. Provides high heat transfer, stainless steel heater is corrosion resistant.
Twidec/ 6x50mm Cylinder Cartridge Heater 110V 100W Hot Rod Heating Element Replacement Electric Heating Pipe Fittings
- Product Name: Cartridge Heater
- Widely used for manufacturing plastic and rubber parts in the car industry or in the food processing industry, etc .
- Material: Stainless Steel,PVC,Nylon
- Main Color: Silver Tone, Blue
- Rated Voltage :AC 110V
- Power :100W
- Heater Size(Approx.): 6 x 50mm/0.23″ x 1.9″(D*L)
- Wire Length(Approx.) :26cm/10.2″；Net Weight :50g
- Package Content :1 x Cartridge Heater
Specially designed for heating applications, such as injection molding machine, dies, hot plates, platens, etc. Provides high heat transfer, stainless steel heater is corrosion resistant.
Dernord 240V 5500W Tri-clamp Ripple Heating Element Stainless Steel Immersion Water Heater with 3-Wire Electrical Locking Plug (1.5 Inch Tri clamp)
- With 3-Wire Electrical Locking Plug, grounded for your safety
- Easy to Install and fits Standard 1.5″ Inch (Ferrule OD 50.5mm) tri-clamp coupler of American
- SUS304 Tri-clamp Ripple Foldback heating element provides 5500w 240v of power
- The shape is to minimize length and maximize heated surfaces
- Resists dry firing, lime deposits, and sand that would burn out ordinary elements
Product Features
5500W Tri-clamp Ripple Foldback heating Element : Replacement American standard water heater parts
From the Manufacturer
Dernord 240V 5500W Tri-clamp Ripple Heating Element Stainless Steel Immersion Water Heater with 3-Wire Electrical Locking Plug has a compact, energy efficient design that is well suited for many applications. The element is folded back to minimize length and maximize the heated surface.It provides uniform heat distribution and offered long performance life, and fits more models of American,for Bradford White, Craftmaster, General Electric and Whirlpool heaters.
Technical Details
Voltage: 240V
Wattage: 5500W
Color: Silver
Tube length: 335mm
Tube diameter: 8mm
Ferrule OD Size:50.5mm
DERNORD 2 Inch (OD64) Tri-clamp 120V 1500W Foldback Heating Element Electric Water Heater with Low Watt Density
- SUS304 Tri-clamp Foldback heating element provides 1500w 240v of power
- Tri-clamp connection: 2″ Tri Clamp
- Ferrule Size: 64mm Pipe OD
- Nylon Cable Gland Joint Adjustable Locknut for PG21 Wire OD 12.5mm to 18mm
- With SUS304 Materials Cap,easy to Install and fits Standard 2″ tri-clover coupler of American
- Prevent dry firing, lime deposits, and sand that would burn out ordinary elements
Product Features
2 Inch (OD64) Tri-clamp 120V 1500W Foldback Heating Element : Replacement American standard water heater parts
From the Manufacturer
The Dernord 120v 1500w Low Watt Density Screw in Foldback Water Heater Element has a compact, energy efficient design that is well suited for many applications. The element is folded back to minimize length and maximize the heated surface.It provides uniform heat distribution and offered long performance life, and fits more models of American,for Bradford White, Craftmaster, General Electric and Whirlpool heaters.
Technical Details
Voltage: 120V
Wattage: 1500W
Mounting Type: Threaded
Connection type: Tri-clamp Type
Tri-clamp Size: 2 Inch
Ferrule Size: 64mm Pipe OD
Dernord 120V 1650W Foldback Water Heater Element Screw-In Lime Life Heating Element with Low Watt Density
- Low Watt Density Stainless Steel Foldback Water Heater Element
- Foldback Water Heater Element provides 1650w 120v of power
- Element is folded back to minimize length and maximize heated surfaces
- Easy to Install and fits most Water Heater Models of American
- Resists dry firing, lime deposits, and sand that would burn out ordinary elements
Product Features
1650W Foldback Water Heater Element : Replacement American standard water heater parts
From the Manufacturer
The Dernord 120v 1650w low Watt Density Screw in Foldback Water Heater Element has a compact, energy efficient design that is well suited for many applications. The element is folded back to minimize length and maximize the heated surface.It provides uniform heat distribution and offered long performance life, and fits more models of American,for Bradford White, Craftmaster, General Electric and Whirlpool heaters.Contains 1 – Element And 1 – Gasket, 12″ Minimum Tank Diameter. Fits Ace, State, Reliance, Sears, Rheem, Rudd, Montgomery Ward And Most Other Water Heaters that use a 120V screw in style replacement.
Technical Details
Item Weight: 11.45 ounces
Origin: China
Color: White
Tube length: 250mm
Tube diameter: 8mm
Item Package Quantity: 1
Mounting Type: Threaded
Twidec/ 8x120mm Cylinder Cartridge Heater 110V 250W Hot Rod Heating Element Replacement Electric Heating Pipe Fittings
- Product Name: Cartridge Heater
- Widely used for manufacturing plastic and rubber parts in the car industry or in the food processing industry, etc .
- Material: Stainless Steel,PVC,Nylon
- Main Color: Silver Tone, Blue
- Rated Voltage :AC 110V
- Power :250W
- Heater Size(Approx.): 8 x 120mm/0.3″ x 4.7″(D*L)
- Wire Length(Approx.) :27cm/10.7″；Net Weight :50g
- Package Content :1 x Cartridge Heater
Specially designed for heating applications, such as injection molding machine, dies, hot plates, platens, etc. Provides high heat transfer, stainless steel heater is corrosion resistant.
DERNORD 1.5" Inch (OD50.5mm) Tri-clamp Ripple Heating Element Electric Immersion Water Heater 5500W 240V
- Stainless Steel Tri-clover Clamp 1.5″ Inch (OD 50.5mm) , fit 1.5″(38mm) pipe if that pipe has a 2″ flange for triclamp
- SUS304 Tri-clamp Ripple Foldback heating element provides 5500w 240v of power
- The shape is to minimize length and maximize heated surfaces
- Easy to Install and fits Standard 1.5″ tri-clover coupler of American
- Prevent dry firing, lime deposits, and sand that would burn out ordinary elements
Product Features
5500W Tri-clamp Ripple Foldback heating Element : Replacement American standard water heater parts
From the Manufacturer
Dernord 240v 5500w Immersion Tri-clamp Ripple Foldback Brewing Water Tubular Heater Element has a compact, energy efficient design that is well suited for many applications. The element is folded back to minimize length and maximize the heated surface.It provides uniform heat distribution and offered long performance life, and fits more models of American,for Bradford White, Craftmaster, General Electric and Whirlpool heaters.
Technical Details
Item Weight: 14 ounces
Origin: China
Color: Silver
Tube length: 333mm
Tube diameter: 8mm
Ferrule Size: 38mm Pipe OD, 50.5mm Ferrule OD
Similar items with 4 stars and above
DERNORD 2 Inch (OD64) Tri-clamp 240V 5500W Foldback Heating Element Electric Water Heater with Low Watt Density
- SUS304 Tri-clamp Foldback heating element provides 5500w 240v of power
- Tri-clamp connection: 2″ Tri Clamp
- Ferrule Size: 64mm Pipe OD
- Nylon Cable Gland Joint Adjustable Locknut for PG21 Wire OD 12.5mm to 18mm
- With SUS304 Materials Cap,easy to Install and fits Standard 2″ tri-clover coupler of American
- Prevent dry firing, lime deposits, and sand that would burn out ordinary elements
Product Features
2 Inch (OD64) Tri-clamp 2400V 5500W Foldback Heating Element : Replacement American standard water heater parts
From the Manufacturer
The Dernord 240v 5500w Low Watt Density Screw in Foldback Water Heater Element has a compact, energy efficient design that is well suited for many applications. The element is folded back to minimize length and maximize the heated surface.It provides uniform heat distribution and offered long performance life, and fits more models of American,for Bradford White, Craftmaster, General Electric and Whirlpool heaters.
Technical Details
Voltage: 240V
Wattage: 5500W
Mounting Type: Threaded
Connection type: Tri-clamp Type
Tri-clamp Size: 2 Inch
Ferrule Size: 64mm Pipe OD
Similar items with 4 stars and above
Conclusion
By our suggestions above, we hope that you can found pipe heating element for you.Please don’t forget to share your experience by comment in this post. Thank you!
